Technological & Science
Park, Lavrio, Greece 19500
Τel: (+30) 22920 69312, 22050, 22010
Fax: (+30) 22920 69303
Nanotechnology for cement surfaces, mortar, grout, stucco and natural or artificial stones..
SurfaPore C creates a water repelling protection by deeply penetrating into the pores of the substrates, and also not creating a “plastic film” on the applied surface.In doing so, the substrate is deeply protected and therefore not affected by abrasion or mechanical wear.
SurfaPore C as a water based, liquid formulation, provides water repellency and protection of a wide range of building surfaces. As its viscosity is similar to that of water, it deeply penetrates into capilaries.It is applied very easily on the surfaces with spray, roller or brush. The nanotechnology based composition assures effectiveness, prolonged lifetime and no change of the original natural appearance. In case moisture is trapped or a water leakage takes place behind a SurfaPore C modified surface, water can evaporate through the open pores to the environment relieving negative capillary pressure. In this manner swelling and cracking of material are prevented.
Natural and artificial stone, cementitious surfaces, walls, basements, terraces
Surface Application: The application surface should be dry and clean. Apply SurfaPore C by using a brush, roller or spraying. No dilution is required. On very absorptive surfaces re-apply within 3 hours.
Mixing: Replace 1/3 of water used in your mix with SurfaPore C. Mix well. In all case (surface application or mixing) test results on a small area before full scale application. Maximum water repellency is achieved 24 hours post application.
Consumption: Estimated consumption rate 8-10 m2/L, strongly dependant on the properties of the surface applied.