LOGIN

SurfaPaint ThermoDry Interior

Thermal Protective Paint for Interior Walls & Ceilings

SurfaPaint ThermoDry Interior is a high quality acrylic colour with thermal protective properties, ideal for interior use.

GENERAL CHARACTERISTICS

SurfaPaint ThermoDry Interior combines a superior quality interior paint with the thermal protective properties of SurfaPore ThermoDry. This paint composition delivers all the benefits of a high quality paint: Scrub resistance, excellent coverage, anti-fungal action, strong adhesion and coating flexibility. SurfaPaint ThermoDry Interior also contains the ideal quantity of SurfaPore ThermoDry that assures all the benefits of a superior thermally protective paint: Significant reduction in thermal conductivity, reflectance of infrared radiation and decreased water absorption of the final coating. Therefore, the application of SurfaPaint ThermoDry Interior can prevent thermal bridges on walls, a frequent phenomenon of poorely insulated surfaces. It is an ideal solution for preventing mould growth by eliminating humidity condensation on cold wall surfaces, along with its anti-fungal properties. Finally, it reduces internal heat losses increasing the energy efficiency of buildings. It can be used as a tinting base for light shades. SurfaPaint ThermoDry Interior is a cool colour, certified by the European Cool Roofs Council (ECRC)..

application surfaces

Internal surfaces (walls, ceilings, concrete, plaster, board)

application note

Applicability: SurfaPaint ThermoDry Interior can be applied directly on interior wall surfaces (masonry, concrete, plaster, drywalls), and wherever water based, acrylic paints are applied. New substrates from cement or masonry should have cured for more than 3-4 weeks before primer application. For better results apply SurfaMix P as a primer.

Preparation: Ensure all surfaces are clean and dry prior to application. Remove any dust and dirt.

Application note: Stir well before application. Do not dilute for bridging gaps and hairline cracks of up to 0,5 mm. For cracks bigger that 1mm, fill the gap with a suitable putty. If thinning is required add up to 10% water by volume. Application temperature should be between 8 - 35oC. Apply 2-3 even coats using a good quality brush, roller or by spraying with a tip of a diameter 1,4mm or more. Do not over-brush. Ensure corners and edges are adequately covered. Additional coats should be applied 4-6 hours after the previous application.

Spreading rate: 10-12 m²/L.

Drying time: Typically 1 hour depending upon coat thickness. Low temperatures and high humidity will lengthen drying times.

mark1POINTS OF SALE Where can you find NanoPhos products
NanoPhos Α.Ε.
Technological & Science 
Park, Lavrio, Greece 19500
Τel: (+30) 22920 69312, 22050, 22010
Fax: (+30) 22920 69303

FIND US ON

Design sandteam   

Website Development ARTIFIEDWEB - WEB DESIGN & DEVELOPMENT

Log in

create an account

fb iconLog in with Facebook

This website uses cookies to manage authentication, navigation, and other functions. Accessing our website, you agree that we can use these types of cookies.

OK